Drill Cycle=Change at point bug??

[MIL-TFP-41]

This did not work in X1MR2 either.

 

When using change at point on a drill cycle, (part is programmed to use incremental depth) the little box beside where you key in your new depth does say "Incr". However, it uses a absolute depth no matter what.

 

 

Anyone else see this?

[crazy^millman]

I just did this again today and not seeing the problem you are having, but what I do see is if you have the parameter page set to absolute then the change at point reflects that like I think it should. If you change it to incremental then the change at point become incremental. Take a look at the first page and see what it here and see if that effects what you are seeing.

 

HTH