multiaxis Moriseiki

[Santa Fe]

On a Moriseiki lathe equipped with live tooling, when working inside G112 interpolation mode, I can do the rough milling and then a finish pas with cutter comp active but the question is: Is it possible to cancel cutter comp G40 after the G113? or G40 needs to be before G113 cancels the interpolation mode???

 

I would like to hear your opinions.

[MIL-TFP-41]

quote:

---

Is it possible to cancel cutter comp G40 after the G113?

---

short answer is no

[lowboy]

I believe you can if you rapid the Z out in front of the part, then cancel.Been doing it for years