MPMASTER ROTATION ?

[dforsythe]

Our old fadal post is lacking a few of the newer commands. I want to switch to the the newer mp master post so we can use the same one on our

Fadal, haas and awea machines with a few slight mods between them so the tool list and comments

And general form look the same to the operators. Any help would be great.

 

Thanks, Damian

 

We have an old post that outputs A rotations like the one shown below

 

N1 T1 M6

( 1/4" X 90 DEG. HSS SPOT DRILL)

S6494 M3

G0 G90 G54 X4.2188 Y0. A0.

G43 H1 Z3.807

G83 G98 X4.2188 Y0. Z1.737 R2.057 I0. J0. K0. F6.49

X3.7188 Y1.1517 Z1.936 A-336.046 R2.256 F6.49

X2.7188 Y.5977 Z1.6503 A347.873 R1.9703 F6.49

X2.7188 Y-.5977 Z1.6508 A12.127 R1.9708 F6.49

X3.7188 Y-1.1517 Z1.9382 A23.954 R2.2582 F6.49

 

I want to switch to the newer MPmaster post but the A rotation are like this

 

N1 T1 M06 ( 1/4" X 90 DEG. HSS SPOT DRILL)

G00 G17 G90 G54 A0. X4.2188 Y0. S6494 M03

G43 H1 Z3.807

G94

G98 G83 Z1.737 R2.057 Q0. F6.49

X3.7188 Y1.1517 Z1.936 A-23.954 R2.256

X2.7188 Y.5977 Z1.6503 A-12.127 R1.9703

Y-.5977 Z1.6508 A12.127 R1.9708

X3.7188 Y-1.1517 Z1.9382 A23.954 R2.2582

[Tony35]

did you try changing these lines in the post

 

one_rev : 0 #Limit rotary indexing between 0 and 360? (0 = No, 1 = Yes)

 

rot_type : 0 #Rotary type - 0=signed continuous, 1=signed absolute, 2=shortest direction

 

HTH

[dforsythe]

That worked great. Thanks!

[Tony35]

your welcome