Error with Dovetail in X7

[CamMan1]

I pulled in an X5 part that had no problems when I originally programmed it. It uses a Dovetail cutter with a radius. You this a lot and have never ran into any problems until I pulled it into X7. Here is the error I get. Anyone else ran into this and if you did howed you work around it.

[Jayson Kramer]

I would rebuild that tool in X7 following the new Tool Manger

[gcode]

The method of defining dovetail cutters has been changed for X7 and you'll probably need to

rebuilding it in X7 to get it to work

[CamMan1]

I understand what you guys are saying but don't you think CNC should inform us of these error codes so that we know what they are related to so we can adjust our tools and programs to compensate for these errors. It's not like this error code is some manual!

[Jeremy Grigsby]

I think they should have used the word "then" instead of "than" in the error message.

[CamMan1]

I think they should have used the word "then" instead of "than" in the error message.

 

Excellent catch on the grammar

[Jeremy Grigsby]

I'm not going to try to be grammar police on a forum. I would be very busy. I just think in a software error message, the spelling/grammar should be correct.

One of our Mori lathes from 1999 tells you to "Please closed the door" on startup. That's from Japan though(translating error).