WCS Problem

[oneyankfan1]

I have come across a new issue I've never seen before. In my view manager I keep getting a WCS named New View #1 and i will erase it but as soon as I open the view manager again it reappears is there a setting I'm missing? I attached a screen shot

[Guest]

You have a created WCS.

 

When you change a plane or a view and your created WCS is the active WCS, the system will create a relative named WCS/Plane/View

 

So if you have "My WCS" created and you switch to a right plane on that, you will get a new plane created relative to your "My WCS"

[CamMan1]

This will happen sometimes when your default safety zone view is set to something other than a standard view. I get this alot when retrieving files from one of are programmers who is still on V9. JP is correct also.

[oneyankfan1]

I havent done anything different than Ive always done, usually when i create a WCS it defaults to a name NEW VIEW [11] or NEW VIEW [12] and have always been able to erase it when i was done with it (used it for contruction) so i dont have wcs that arent used for tool paths and have a bunch of clutter. But this one is different its named NEW VIEW #1 and cant get it erased off of my view manager

[oneyankfan1]

i found the problem i had a manual entry that it was assigned to had to use edit common perameters to change it. thanks guys

[Guest]

i found the problem i had a manual entry that it was assigned to had to use edit common perameters to change it. thanks guys

 

That will do it, if anything references it, it will be created